User Manual

Instruction Manual 11
20
resume
resume [taskname | task ID]
resume task taskname or task ID
21
route
route [add | delete | -a] <host |
net> <dest> <gateway>
IP routing table maintenance
22
setenv
setenv <ENV_VAR=value>
set environment variable ENV_VAR to
value, or if no parameters show all
environment variables
23
setid
setid [uid] [gid] set user and group Ids
24
setpri
setpri [taskname | tid] [priority]
set task taskname or task ID priority to
priority
25
sleep
sleep [seconds]
suspend shell execution for seconds
seconds
26
suspend
suspend [taskname | tid]
suspend task taskname or task ID
27
ber
ber [subchannel (0-3)] <frequency
(seconds)>
toggle bit error rate display on the
specified subchannel
28
flashcrc
flashcrc [target pid | all]
report the flash CRC of the requested PID
29
getRev
getRev [target pid | all] report the software revision of on the
requested PID
30
remlog
Remlog toggles msgLog on telnet sessions
31
wmsl
wmsl [target PID] [b|h|w]
[address] [value]
write value at address on slave PID using
byte, half-word, or word access
32
dmsl
dmsl [target PID] [b|h|w] [address]
<length>
read (dump) length bytes of memory at
address on PID using byte, half-word, or
word access
33
ipcsl
ipcsl [target PID]
report IPC info for PID
34
rxmqueue
Rxmqueue report info for the RXM I/Q sample circular
queue
35
txmdac
Txmdac report info for the TXM transmit DAC
buffer
36
cpdbg
cpdbg [target PID]
report info for the CP with PID pid
37
statedbg
Statedbg report info for the RXM call state machine
38
time
Time display RC860 system time
39
syspar
syspar <r | w> <parameter>
<value>
read or write parameter with value if
writing; no parameters lists all system
parameters and current values
40
sysStatus
SysStatus User-friendly display of repeater statuses,
as seen by the RC860
41
reset860
reset860 resets the entire repeater
42
shutdown
Shutdown stops all RX and TX on the repeater
43
resetSysP
arms
ResetSysParms resets all non-volatile parameters to
defaults
44
prescheck
Prescheck displays task and slave processor
presence
45
flashld
flashld [pid]
prepare PID to receive flash image
46
iflock
Iflock displays RF lock status
47
chuser
chuser <-adhm> <username>
change telnet user - add a new user,
delete user, help, modify user password
48
startnow
Startnow start repeater initialization now, skipping
warm-up timer
49
log
Log toggles msgLog on CONSOLE shell
50
taskdbg
taskdbg [DPR|PA|RF|SCON]
<pid|amp>
display task DPR, PA, RF, or SCON
debug info
51
memtest
memtest [h | w] [address]
<length>
test memory at address for length bytes
using half-word or word access