User Manual

Getting Started With EZ-
www.cypress.com Document No.: 001-96841 Rev. ** 17
CYB LE -022001- E V AL C o n ne c ti on s to C Y 8 C KI T -042- B L E
The CYBLE-022001-00 module contains 21 connections on the back side of the module. Each of these connections is present
on the CYBLE-022001-EVAL evaluation board too.
Figure 18 shows the CYBLE-022001-EVAL and highlights the elements on the top side of the board.
Figure 18. CYBLE-022001-EVAL Board Top Side
The CYBLE-022001-EVAL also includes the following elements:

C
mod
: A 2.2-nF capacitor mounted on the evaluation board used with the CY8CKIT-042-BLE capacitive sensing slider,
buttons and proximity sensors.

J3 Header: A two-pin header that exposes VDD and VDDR.

J4 Header: A five-pin header that exposes connections used for programming the EZ-BLE PRoC Module Evaluation
board by using the MiniProg3 kit, as shown in Figure 19.
Figure 19. CYBLE-022001-EVAL Using CY8CKIT-002 MiniProg3
 J5: A header that exposes P5[0] and P5[1], which can be used for I
2
C communication (including high speed I
2
C) to the
EZ-BLE PRoC Module.
J5 Header