User Manual

Getting Started With EZ-
www.cypress.com Document No.: 001-96841 Rev. ** 23
Figure 22. My First EZ-BLE PRoC Module Design
Creating your first EZ-BLE PRoC Module design involves four main steps:
1. Create the design in the PSoC Creator schematic page.
2. Write the application code to initialize and handle Bluetooth Low Energy events and take action.
3. Program the EZ-BLE PRoC Module on the BLE Pioneer Kit.
4. Test your design using the CySmart PC application or mobile app.
Create the Design
This section takes you on a step-by-step guided tour of the
design process. It starts with creating an empty project
and guides you through hardware and firmware design
entry. You can skip this section if you simply wish to try
the example project provided with this application note
without going through the build process.
1. Install PSoC Creator 3.1 SP2 or higher on your PC
from the webpage PSoC Creator home page. After
installation, a registration page for Keil license will be
shown. This can be ignored for EZ-BLE PRoC
Module.
2. Start PSoC Creator, and choose File > New >
Project, as Figure 23 shows.
Figure 23. Creating a New Project