User Manual

Getting Started With EZ-
www.cypress.com Document No.: 001-96841 Rev. ** 45
7. When the pin assignment table is displayed, you will notice that two of the connections have been unassigned. This is due
to the limited I/O supported on the EZ-BLE PRoC Module. Both Disconnect_LED and Wakeup_SW will be shown as
unassigned.
8. To complete the assignments, assign P3[4] to Disconnect_LED and P3[5] to Wakeup_SW. These connections can be
determined through checking the CY8CKIT-042-BLE and CYBLE-022001-EVAL schematics.
9. Build the application as shown in Figure 54.
10. Program the CYBLE-022001-EVAL as shown in Figure 57.
11. Proceed to the next section to test your design.