User Manual

Getting Started With EZ-
www.cypress.com Document No.: 001-96841 Rev. ** 56
ANTENNA WARNING
This device is tested with a standard SMA connector and with the antennas listed below. When
integrated in the OEMs product, these fixed antennas require installation preventing end-users
from replacing them with non-approved antennas. Any antenna not in the following table must
be tested to comply with FCC Section 15.203 for unique antenna connectors and Section
15.247 for emissions.
Table 7: Antenna used in the module
Manufacturer
Part Number
Frequency Band
Antenna Type
Gain
Johanson
Technologies
2450AT18B100
2.4 GHz
Chip
+0.5 dBi
RF EXPOSURE
To comply with FCC RF Exposure requirements, the Original Equipment Manufacturer (OEM)
must ensure to install the approved antenna in the previous.
The preceding statement must be included as a CAUTION statement in manuals, for products
operating with the approved antennas in the previous table, to alert users on FCC RF Exposure
compliance.
Any notification to the end user of installation or removal instructions about the integrated radio
module is not allowed.
The radiated output power of CYBLE-022001-00 with the chip antenna mounted (FCC ID:
WAP2001) is far below the FCC radio frequency exposure limits. Nevertheless, use CYBLE-
022001-00 in such a manner that minimizes the potential for human contact during normal
operation.
End users may not be provided with the module installation instructions. OEM integrators and
end users must be provided with transmitter operating conditions for satisfying RF exposure
compliance.
INDUSTRY CANADA CERTIFICATION
CYBLE-022001-00 is licensed to meet the regulatory requirements of Industry Canada (IC),
License: IC: 7922A-2001
Manufacturers of mobile, fixed or portable devices incorporating this module are advised to
clarify any regulatory questions and ensure compliance for SAR and/or RF exposure limits.
Users can obtain Canadian information on RF exposure and compliance from www.ic.gc.ca.
This device has been designed to operate with the antennas listed in table 7 above, having a
maximum gain of 0.5 dBi. Antennas not included in this list or having a gain greater than 0.5 dBi
are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. The