User's Manual

Document Number: 002-xxxxx Rev. ** Page 33 of 42
PRELIMINARY
CYBLE-013025-00
CYBLE-013030-00
Environmental Specifications
Environmental Compliance
This Cypress BLE module is produced in compliance with the Restriction of Hazardous Substances (RoHS) and Halogen-Free (HF)
directives. The Cypress module and components used to produce this module are RoHS and HF compliant.
RF Certification
The CYBLE-0130XX-00 module will be certified under the following RF certification standards at production release.
n FCC: WAP3025
n CE
n IC: 7922A-3025
n MIC: TBD
Safety Certification
The CYBLE-0130XX-00 module complies with the following safety regulations:
n Underwriters Laboratories, Inc. (UL): Filing E331901
n CSA
n TUV
Environmental Conditions
Tab l e 24 describes the operating and storage conditions for the Cypress BLE module.
ESD and EMI Protection
Exposed components require special attention to ESD and electromagnetic interference (EMI).
A grounded conductive layer inside the device enclosure is suggested for EMI and ESD performance. Any openings in the enclosure
near the module should be surrounded by a grounded conductive layer to provide ESD protection and a low-impedance path to ground.
Device Handling: Proper ESD protocol must be followed in manufacturing to ensure component reliability.
Table 24. Environmental Conditions for CYBLE-0130XX-00
Description Minimum Specification Maximum Specification
Operating temperature −30 °C 85 °C
Operating humidity (relative, non-condensation) 5% 85%
Thermal ramp rate
– 3 °C/minute
Storage temperature
–40 °C 85 °C
Storage temperature and humidity
– 85 °C at 85%
ESD: Module integrated into system Components
[6]
–
15 kV Air
2.0 kV Contact
Note
6. This does not apply to the RF pins (ANT).