User's Manual

Document Number: 002-19525 Rev. ** Page 29 of 49
PRELIMINARY
CYBT-343026-01
CYBT-343029-01
CYBT-143038-01
Table 17. Transmitter RF Specifications
Table 18. BLE RF Specifications
Parameter Conditions Minimum Typical Maximum Unit
General
Frequency range – 2402 – 2480 MHz
Class1: GFSK Tx power
1
1. TBD dBm output for GFSK measured with PAVDD = 2.5V.
––12–dBm
Class1: EDR Tx power
2
2. TBD dBm output for EDR measured with PAVDD = 2.5V.
––9–dBm
Class 2: GFSK Tx power – – 2 – dBm
Power control step – 2 4 8 dB
Modulation Accuracy
π/4-DQPSK Frequency Stability – –10 – 10 kHz
π/4-DQPSK RMS DEVM – – – 20 %
π/4-QPSK Peak DEVM – – – 35 %
π/4-DQPSK 99% DEVM – – – 30 %
8-DPSK frequency stability – –10 – 10 kHz
8-DPSK RMS DEVM – – – 13 %
8-DPSK Peak DEVM – – – 25 %
8-DPSK 99% DEVM – – – 20 %
In-Band Spurious Emissions
1.0 MHz < |M – N| < 1.5 MHz – – – –26 dBc
1.5 MHz < |M – N| < 2.5 MHz – – – –20 dBm
|M – N| >
2.5 MHz – – – –40 dBm
Out-of-Band Spurious Emissions
30 MHz to 1 GHz – – – –36.0
3
3. Maximum value is the value required for Bluetooth qualification.
dBm
1 GHz to 12.75 GHz – – –
–30.0
<Super-
script>3, 4
4. Meets this spec using a front-end band-pass filter.
dBm
1.8 GHz to 1.9 GHz – – – –47.0 dBm
5.15 GHz to 5.3 GHz – – – –47.0 dBm
Parameter Conditions Minimum Typical Maximum Unit
Frequency range N/A 2402 – 2480 MHz
Rx sense
1
1. Dirty Tx is Off.
GFSK, 0.1% BER, 1 Mbps – –96.5 – dBm
Tx power
2
2. The BLE Tx power can be increased to compensate for front-end losses such as BPF, diplexer, switch, etc. The output is capped at 12 dBm out. The BLE Tx power
at the antenna port cannot exceed the 10 dBm EIRP specification limit.
N/A –9–dBm
Mod Char: Delta F1 average N/A 225 255 275 kHz
Mod Char: Delta F2 max
3
3. At least 99.9% of all delta F2 max frequency values recorded over 10 packets must be greater than 185 kHz.
N/A 99.9 – – %
Mod Char: Ratio N/A 0.8 0.95 – %