Specifications

Document Number: 002-26540 Rev. ** Page 28 of 45
PRELIMINARY
CYBT-213043-02
Chipset RF Specifications
Table 20, Table 21, Table 22, and Table 23 apply to single-ended industrial temperatures. Unused inputs are left open.
Table 20. BR/EDR - Receiver RF Specifications
Parameter Mode and Conditions Min Typ Max Unit
Receiver Section
Frequency range – 2402 – 2480 MHz
RX sensitivity
GFSK, BDR GFSK 0.1% BER, 1 Mbps – –92
[]
–dBm
EDR 2M – –93.5 –
dB
EDR 3M – –87 –
Maximum input – –20 – – dBm
Interference Performance
C/I cochannel GFSK, BDR GFSK 0.1% BER
[]
––11.0
dB
C/I 1 MHz adjacent channel GFSK, BDR GFSK 0.1% BER
[]
––0.0
C/I 2 MHz adjacent channel GFSK, BDR GFSK 0.1% BER
[]
– – –30.0
C/I 3 MHz adjacent channel GFSK, BDR GFSK 0.1% BER
[]
– – –40.0
C/I image channel GFSK, BDR GFSK 0.1% BER
[]
–––9.0
C/I 1 MHz adjacent to image channel GFSK, BDR GFSK 0.1% BER
[]
– – –20.0
Out-of-Band Blocking Performance (CW)
[]
30 MHz to 2000 MHz BDR GFSK 0.1% BER – –10.0 –
dBm
2000 MHz to 2399 MHz BDR GFSK 0.1% BER – –27 –
2498 MHz to 3000 MHz BDR GFSK 0.1% BER – –27 –
3000 MHz to 12.75 GHz BDR GFSK 0.1% BER – –10.0 –
Intermodulation Performance
[]
BT, interferer signal level BDR GFSK 0.1% BER – – –39.0 dBm
Spurious Emissions
30 MHz to 1 GHz – – – –57.0
dBm
1 GHz to 12.75 GHz – – – –55.0
.
Notes
6. The receiver sensitivity is measured at BER of 0.1% on the device interface with dirty TX Off.
7. Desired signal is 10 dB above the reference sensitivity level (defined as –70 dBm).
8. Desired signal is 3 dB above the reference sensitivity level (defined as –70 dBm).
9. Desired signal is –64 dBm Bluetooth-modulated signal, interferer 1 is –39 dBm sine wave at frequency f1, interferer 2 is –39 dBm Bluetooth-modulated signal at
frequency f2, f0 = 2 * f1 – f2, and |f2 – f1| = n * 1 MHz, where n = 3, 4, or 5. For the typical case, n = 4.