Specifications

Document Number: 002-29172 Rev. ** Page 36 of 45
PRELIMINARY
CYBT-223058-02
CYBT-253059-02
Environmental Specifications
Environmental Compliance
This Cypress Bluetooth module is produced in compliance with the Restriction of Hazardous Substances (RoHS) and Halogen-Free
(HF) directives. The Cypress module and components used to produce this module are RoHS and HF compliant.
RF Certification
The CYBT-2x305x-02 module is certified under the following RF certification standards:
■ FCC: WAP3058
■ ISED: 7922A-3058
■ MIC: TBD
■ CE
Safety Certification
The CYBT-2x305x-02 module complies with the following safety regulations:
■ Underwriters Laboratories, Inc. (UL): Filing E331901
■ CSA
■ TUV
Environmental Conditions
Tab l e 30 describes the operating and storage conditions for the Cypress Bluetooth module.
ESD and EMI Protection
Exposed components require special attention to ESD and electromagnetic interference (EMI).
A grounded conductive layer inside the device enclosure is suggested for EMI and ESD performance. Any openings in the enclosure
near the module should be surrounded by a grounded conductive layer to provide ESD protection and a low-impedance path to ground.
Device Handling: Proper ESD protocol must be followed in manufacturing to ensure component reliability.
Table 30. Environmental Conditions for CYBT-2x305x-02
Description Minimum Specification Maximum Specification
Operating temperature −30 °C 85 °C
Operating humidity (relative, non-condensation) 5% 85%
Thermal ramp rate
– 10 °C/minute
Storage temperature
–40 °C 85 °C
Storage temperature and humidity
– 85 °C at 85%
ESD: Module integrated into system Components
[23]
–
15 kV Air
2.0 kV Contact
Note
23. This does not apply to the RF pins (ANT).