User's Manual

Document Number: 002-19043 Rev. PRELIMINARY Page 22 of 33
PRELIMINARY
CYBLE-413136-01
RF Specifications
Note: Table 15 and Table 16 apply to single-ended industrial temperatures. Unused inputs are left open.
Table 15. Receiver RF Specifications
Parameter Mode and Conditions Min Typ Max Unit
Receiver Section
Frequency range – 2402 – 2480 MHz
RX sensitivity GFSK, BDR GFSK 0.1% BER, 1 Mbps
Module
– –93.0 – dBm
Maximum input – –20 – – dBm
Table 16. Transmitter RF Specifications
Parameter Min Typ Max Unit
Transmitter Section
Frequency range 2402 – 2480 MHz
Class 2: GFSK Tx power (silicon) – 4 – dBm
Class 2: GFSK Tx power (module) – 8 – dBm
20 dB bandwidth – 930 1000 kHz
Frequency Drift
DH1 packet –25 – +25 kHz
DH3 packet –40 – +40 kHz
DH5 packet –40 – +40 kHz
Drift rate –20 20 kHz/50 µs
Frequency Deviation
Average deviation in payload
(sequence used is 00001111)
140 – 175 kHz
Maximum deviation in payload
(sequence used is 10101010)
115 – – kHz
Channel spacing – 1 – MHz
Table 17. BLE RF Specifications
Parameter Conditions Minimum Typical Maximum Unit
Frequency range N/A 2402 – 2480 MHz
Rx sensitivity
1
1. Dirty Tx is Off.
GFSK, BDR GFSK 0.1% BER 0.1%
BER, 1 Mbps
– –93.0 – dBm
Tx power N/A – 4 – dBm
Mod Char: Delta F1 average N/A 225 255 275 kHz
Mod Char: Delta F2 max
2
2. At least 99.9% of all delta F2 max frequency values recorded over 10 packets must be greater than 185 kHz.
N/A 99.9 – – %
Mod Char: Ratio N/A 0.8 0.95 – %