User manual

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B 18

Kit Operation

3.1 Powering the Kit

To power the kit, connect the A to Mini-B USB cable, provided with the kit, to your PC or laptop. The

kit enumerates as a composite device (see Table 3-1), and three separate devices appear under the

Device Manager (Start > Control Panel > Device Manager) option of the Windows operating sys-

tem, as shown in Figure 3-5.

Table 3-1. CY3280-MBR3 Evaluation Kit in Device Manager after Enumeration

Note: Although the kit supports a programmer and a UART bridge, these functionalities are not used

with this kit. Do not use PSoC Programmer to communicate with the PSoC 5LP on the kit, as it may

corrupt the kit firmware.

Figure 3-3. KitProg Driver Installation

Figure 3-4. KitProg Driver Installation Complete

After the driver installation is complete, all the above devices are listed in the Device Manager, as

shown in Figure 3-5.

Port Description

USB input device

USB-I

C bridge

KitProg programmer Programmer and debugger

KitProg USB-UART USB-UART bridge appears as COM# port