User manual

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B 64
Configuration Files and Example Projects
Figure 5-22. PSoC Creator Schematic
5.3.1.2 Hardware Connections
Connect the CY3280-MBR3 EVK to the PSoC 4 Pioneer Kit, as discussed in PSoC 4 Host Example
Projects on page 62.
Ensure that the jumper J15 is connected in position A (see Figure 5-21). Table 5-2 shows the pin
connections used for I
2
C communication; the corresponding pins of the EVK are connected to the
CY8CMBR3116 device I
2
C pins.
Table 5-2. Pin Connections
Ensure that I
2
C selection jumpers J13 and J14 are shorted on pins 2 and 3, as shown in Figure 5-21.
Component Pin Name Port Pin Used
I2C – SCL P4[0]
I2C – SDA P4[1]
Blue LED P0[3]
Red LED P1[6]