User manual

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B 69
Configuration Files and Example Projects
Figure 5-30. PSoC Creator Schematic
5.3.2.2 Hardware Connections
Connect the CY3280-MBR3 EVK to the PSoC 4 Pioneer Kit, as shown in Figure 5-20. Ensure that
the jumper J15 is connected in position A (see Figure 5-21). No specific hardware connection is
required for this project because all connections are hard wired.
Table 5-3 lists the pin connections used for I
2
C communication; the corresponding pins of the EVK
are connected to the CY8CMBR3116 device I
2
C pins.
Table 5-3. Pin Connections
Component Pin Name Port Pin Used
HostInt_Pin P0[7]
I2C – SCL P4[0]
I2C – SDA P4[1]
Red_LED P1[6]
Green_LED P0[2]
Blue_LED P0[3]