User manual

CY3280-MBR3 Evaluation Kit User Guide, Doc. #: 001-89905 Rev. *B 8
Introduction
1.1 Kit Contents
The CY3280-MBR3 EVK includes the following components (see Figure 1-1):
■ CY3280-MBR3 EVK with a 2-mm overlay
■ One additional overlay of 1-mm thickness
■ A to Mini-B USB cable
■ Water dropper
Figure 1-1. Kit Contents
Inspect the contents of the kit. If you find any part missing, contact your nearest Cypress sales office
for help: www.cypress.com/go/support.
1.2 Getting Started
This kit guide helps to familiarize you with the CY3280-MBR3 EVK. The Kit Installation chapter on
page 11 describes the installation of the EVK software. The Kit Operation chapter on page 16
explains how to configure the CY8CMBR3116 controller on the kit to test different features using the
EZ-Click 2.0 customizer tool. The hardware details, and configuration files and example projects are
explained in their respective chapters. The configuration files and example projects require EZ-Click
and PSoC Creator™, respectively. The Advanced Topics chapter on page 74 describes how to use
the Bridge Control Panel (BCP) to configure the MBR3 device. The Appendix on page 79 provides
the schematics, board layout, pin assignment, and the bill of materials (BOM).