User Manual Part 1

CY8CKIT-042-BLE Bluetooth® Low Energy (BLE) Pioneer Kit Guide, Doc. # 001-93731 Rev. *A 27
Kit Operation
To remove the BLE modules from the BLE Pioneer kit, hold the BLE Pioneer kit in one hand and the
BLE module in the other, as shown in Figure 3-6, and pull it out using a rocking motion.
Figure 3-6. Remove BLE Module Connected on BLE Pioneer Kit
3.4 Programming and Debugging BLE Device
The BLE Pioneer kit and BLE dongle can be programmed and debugged using the onboard
PSoC 5LP programmer and debugger. Before programming the device, ensure that PSoC Creator
and PSoC Programmer are installed on the PC. See the section Install Software on page 20 for
more information.
3.4.1 Programming and Debugging using PSoC Creator
1. To program the BLE Pioneer kit, plug the USB cable into the programming USB connector, J13,
and connect it to the USB port on the PC, as shown in Figure 3-7. The kit will enumerate as a
composite device.