User Manual Part 1

CY8CKIT-042-BLE Bluetooth® Low Energy (BLE) Pioneer Kit Guide, Doc. # 001-93731 Rev. *A 29
Kit Operation
4. To load the desired example project, open PSoC Creator and go to File > Open > Project/
Workspace. This will provide the option to browse to and open your saved project.
5. Build the project by choosing Build > Build <Project Name> or [Shift] [F6], as shown in
Figure 3-10.
Figure 3-10. Build an Example Project
6. If there are no errors during build, program the firmware into the kit by choosing Debug >
Program or pressing [Ctrl] [F5], as shown in Figure 3-11. This will program the device on the
BLE Pioneer Kit/BLE dongle and it will be ready for use. If debugging is needed on the project, go
to step 6.
Figure 3-11. Programming Device From PSoC Creator
7. To debug the project using PSoC Creator, choose
Debug > Debug or press [F5].
8. When the project is built and programmed into the device on the BLE Pioneer kit/BLE dongle,
PSoC Creator will enter the Debug mode; you can use it to debug your application. For more
details on using the debug features, see the Cypress application note Getting Started with PSoC
4 BLE.