User Manual Part 1

CY8CKIT-042-BLE Bluetooth® Low Energy (BLE) Pioneer Kit Guide, Doc. # 001-93731 Rev. *A 30
Kit Operation
3.4.2 Programming using PSoC Programmer
PSoC Programmer (3.21 or later) can be used to program existing hex files into the BLE Pioneer kit
or BLE dongle. To do this, follow these steps.
1. To program the BLE Pioneer kit, plug the USB cable into the programming USB connector, J13,
and connect it to the PC USB port, as shown in Figure 3-7. The kit will enumerate as a composite
device.
Figure 3-12. Connect BLE Pioneer Kit to PC
2. To program the BLE dongle, plug the dongle to the USB port of the PC, as shown in Figure 3-13.
The kit will enumerate as a composite device.
Figure 3-13. Connect BLE Dongle to PC
3. Go to
Start > All Programs > Cypress > PSoC Programmer <version> > PSoC Programmer
<version>. The PSoC Programmer window will open as shown in Figure 3-13.
Note: BLE projects support PSoC Programmer 3.21 or later.