User Manual Part 1

CY8CKIT-042-BLE Bluetooth® Low Energy (BLE) Pioneer Kit Guide, Doc. # 001-93731 Rev. *A 8
Regulatory Compliance Information
The kit contains devices that transmit and receive radio signals in accordance with the spectrum
regulations for the 2.4-GHz unlicensed frequency range.
Cypress Semiconductor Corporation has obtained regulatory approvals for this kit to be used in
specific countries. These countries include United States (FCC Part 15), Canada (IC RSS210) and
Japan (JRF/ TELEC). Additional regional regulatory agency approval may be required to operate
these throughout the world.
This kit as shipped from the factory has been tested and found to comply with the limits/
requirements for following compliances:
■ FCC as a class B digital device, pursuant to part 15 of the FCC Rules.
■ This Class B digital apparatus complies with Canadian ICES-003
Regulatory statements and Product Labeling
United States (FCC)
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The CY8CKIT-142 PSoC 4 BLE and CY5671 PRoC BLE modular transmitter must be labeled with
its own FCC ID number, and, if the FCC ID is not visible when the module is installed in to another
device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording such as the following:
Contains FCC ID: WAP-CY8CKIT-142 and WAP-CY5671, The enclosed device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference and (2) this device must accept any interference received, including
interference that may cause undesired operation. Any similar wording that expresses the same
meaning may be used.
CAUTION: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
Only the PCB antenna(s) that were certified with the module may be
used. Other antennas may be used only if they are of the same type
and have the same or lower gain.
The module must be recertified as a Class II permissive change if the
module is built into a different device than the EVB (evaluation board)
it was certified with
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO
OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER'S AUTHORITY TO OPERATE THE
EQUIPMENT.