User Manual Part 1

CY8CKIT-042-BLE Bluetooth® Low Energy (BLE) Pioneer Kit Guide, Doc. # 001-93731 Rev. *A 80
Example Projects
Figure 4-62. Set Central IAS Project as Active
6. Program the BLE Pioneer kit with either the
PSoC_4_BLE_Central_IAS or the
PRoC_BLE_Central_IAS project, depending on the BLE module placed on the BLE Pioneer kit.
7. Press button
SW2 on the BLE Pioneer kit to wake the system and start scanning. Scanning is
indicated by a blinking LED.
8. Wait for the BLE connection between the dongle and the Pioneer baseboard. The connection
success status is indicated on the baseboard in the following three stages:
a. Fast blinking blue LED represents scanning mode. During this mode, the BLE Pioneer kit is
scanning for peripheral devices.
b. Slow blinking blue LED represents discovery mode. During this mode, the BLE Pioneer kit has
found the dongle peripheral device and has started the connection procedure.
c. The blue LED remains on, representing the connected mode. This mode indicates that the
peripheral device has been connected and the application can now send alert levels.
9. Press button
SW2 on the BLE Pioneer kit to send the next alert level to the dongle. The alert level
will rotate from No Alert to Mid Alert to High Alert.
10.Check if the LED behavior changes for each alert notification on the dongle according to the
following table:
Alert Level LED State
No Alert LED OFF
Mild Alert LED blinking
High Alert LED ON