User Manual Part 1

CY8CKIT-042-BLE Bluetooth® Low Energy (BLE) Pioneer Kit Guide, Doc. # 001-93731 Rev. *A 87
Example Projects
4.6.3 Verify Output
1. Connect the BLE Pioneer kit through the USB connector J13.
2. Program the BLE Pioneer kit with the PSoC_4_BLE_DTM or PRoC_BLE_DTM project, depend-
ing on the BLE module used (PSoC 4 BLE or PRoC BLE), as described in Using Example Proj-
ects on page 42. Programming should complete successfully.
3. Connect the Serial link, UART or RS232 to the tester.
4. On the software tool for tester, configure the UART communication with the correct COM port and
baud rate, as set in the BLE component.
5. Start the test. The tool will generate the report after the end of the test. This depends on the tes-
ter/tool being used.
Table 4-4. UART Pin Assignment for RS232 Voltage Translator
UART Pins Pin Assigned
RX P0_0
TX P0_1
RTS P0_2
CTS P0_3