User Manual Part 1

CY8CKIT-042-BLE Bluetooth® Low Energy (BLE) Pioneer Kit Guide, Doc. # 001-93731 Rev. *A 94
Hardware
■ When the board is powered from an external voltage supply, remove the USB port (J13). Connect
the positive terminal of the external voltage supply to the positive terminal of the ammeter and the
negative terminal of the ammeter to the upper pin of J15. Connect the negative terminal of the
external voltage supply to and GND pin on board. Figure 5-7 shows the required connections.
Figure 5-7. Current Measurement when Powered Separately
5.1.3 Programming Interface
The kit allows you to program and debug the PSoC 4 BLE/PRoC BLE in two ways:
■ Using the onboard PSoC 5LP Programmer and Debugger
■ Using a CY8CKIT-002 MiniProg3 Programmer and Debugger
VOLTAGE
SOURCE
- +