User Manual Part 1

CY8CKIT-042-BLE Bluetooth® Low Energy (BLE) Pioneer Kit Guide, Doc. # 001-93731 Rev. *A 96
Hardware
5.1.4.2 PMod Connector - Digilent Pmod Compatible (J5-unpopulated)
This port supports Digilent Pmod peripheral modules (see Figure 5-9). Pmods are small I/O
interfaces that connect with the embedded control boards through either 6- or 12-pin connectors.
The BLE Pioneer kit supports the 6-pin Pmod type 2 (SPI) interface. For Digilent Pmod cards, go to
www.digilentinc.com.
This header is not populated on the BLE Pioneer board. You must populate this header before
connecting the Pmod daughter cards. Refer to the “No Load Components” section of Bill of Materials
(BOM) on page 184 for the header part number.
Figure 5-9. Schematics and Board Highlight of PMod Connector
Digilent
®
Pmod
TM
-
compatible I/O
header (J5)