User manual

CY8C24223A, CY8C24423A
Document Number: 38-12029 Rev. *H Page 31 of 34
Device Programmers
All device programmers can be purchased from the Cypress
Online Store.
CY3210-MiniProg1
The CY3210-MiniProg1 kit allows a user to program PSoC
devices via the MiniProg1 programming unit. The MiniProg is a
small, compact prototyping programmer that connects to the PC
via a provided USB 2.0 cable. The kit includes:
■ MiniProg Programming Unit
■ MiniEval Socket Programming and Evaluation Board
■ 28-Pin CY8C29466-24PXI PDIP PSoC Device Sample
■ PSoC Designer Software CD
■ Getting Started Guide
■ USB 2.0 Cable
CY3207ISSP In-System Serial Programmer (ISSP)
The CY3207ISSP is a production programmer. It includes
protection circuitry and an industrial case that is more robust than
the MiniProg in a production-programming environment.
Note: CY3207ISSP needs special software and is not
compatible with PSoC Programmer. This software is free and
can be downloaded from http://www.cypress.com. The kit
includes:
■ CY3207 Programmer Unit
■ PSoC ISSP Software CD
■ 110 ~ 240V Power Supply, Euro-Plug Adapter
■ USB 2.0 Cable
Accessories (Emulation and Programming)
Third Party Tools
Several tools have been specially designed by the following
3rd-party vendors to accompany PSoC devices during devel-
opment and production. Specific details for each of these tools
can be found at http://www.cypress.com under Design
Resources > Evaluation Boards.
Build a PSoC Emulator into Your Board
For details on how to emulate your circuit before going to volume
production using an on-chip debug (OCD) non-production PSoC
device, see Application Note “Debugging - Build a PSoC
Emulator into Your Board - AN2323” at http://www.cypress.com.
Table 29. Emulation and Programming Accessories
Part Number Pin Package Pod Kit
[19]
Foot Kit
[20]
Adapter
[21]
CY8C24223A-12PVXE 20 SSOP CY3250-24X23A CY3250-20SSOP-FK
Adapters can be found at
http://www.emulation.com.
CY8C24423A-12PVXE 28 SSOP CY3250-24X23A CY3250-28SSOP-FK
Notes
19. Pod kit contains an emulation pod, a flex-cable (connects the pod to the ICE), two feet, and device samples.
20. Foot kit includes surface mount feet that can be soldered to the target PCB.
21. Programming adapter converts non-DIP package to DIP footprint. Specific details and ordering information for each of the adapters can be found at
http://www.emulation.com.
[+] Feedback [+] Feedback