Datasheet

110 PSoC Designer IDE Guide, Document # 001-42655 Rev *B

Debugger

The PSoC ICE User Guide teaches you how to connect the ICE to your computer, configure the soft-

ware to enable communication and debugging between PSoC Designer and the Pod, and trouble-

shoot the ICE installation. The PSoC Programmer User Guide (referred in 7.7 “Programming the

Part“ on page 130) teaches you how to open a HEX file, select a communication port, set a device,

set a programming mode, program, verify, read, and run a checksum.

The following PSoC part families support I

C debugging:

■ CY8CTMA300

■ CY8CTMG300

■ CY8CTST300

C debugging requires the following components:

■ PSoC Designer 5.0 SP4 or later

■ PSoC Programmer 3.05 or later

■ A MiniProg3

■ A USB cable

■ A Target board with a 5-pin ISSP header (common with other PSoC devices)