Datasheet

PSoC Designer IDE Guide, Document # 001-42655 Rev *B 113
Debugger
menu item. The results of the connection attempt are displayed in the Output window. A successful
connection displays this message:
The status bar shown in Figure 7-3 also shows information associated with debugging.
Figure 7-3. Debug Status Bar.
7.4 Downloading to the Pod
Before you begin a debug session you need to download your project .hex file to the pod. By doing
this, you load the ROM addressing data into the emulation bondout device (chip on the pod). A gen-
eral rule to follow before downloading is to make sure there is not a part in the programming socket
of the Pod. Otherwise, debug sessions may fail.
To download the .hex file to the Pod:
1. Click the Download to Emulator (Pod) icon .
The system downloads the project .hex file located in the …\output folder of your project direc-
tory. A progress indicator reports download status.
2. Once the download is complete, the pod can be directly connected to and debugged on your spe-
cific circuit board.
If you cannot debug your project with the current pod, you receive this message:
This project is incompatible with the Pod/Chip.
This appears in the Debug tab of the Output Status window:
Unable to connect to ICE due to pod incompatibility with project.
Found: debugger version 6a, pod ID 8, pod micro CY8C25/26xxx rev D
Check the Project/Pod compatibility document.
Connecting . . .
ICE Port: USB/0611C003
Pod powered by the ICE
Connected.