Datasheet

PSoC Designer IDE Guide, Document # 001-42655 Rev *B 131
Debugger
Alternatively, the device can be programmed on the target board using the Serial Programming
Header on the Pod. The five connections that must be made from the Serial Programming Header to
the pins on the target device are listed in Table 7-3.
NOTE: Note: It is important to note that there is a limit to the amount of current that can be supplied
to the Vdd pin from the emulator pod (500 mA at 5V). If you draw greater current through the Vdd
pin
on the programming header, this could damage the emulator. You must supply the connections on
the target board for serial programming in the system.
Once part programming is complete, you test the program part directly on your development circuit
board.
Table 7-3. Header to Device Pin Connections
Header Pin Device Pin
1Vdd
2Vss
3XRES
4 P1 [1]/SCLK
5 P1 [0]/SDATA