Datasheet

PSoC Designer IDE Guide, Document # 001-42655 Rev *B 29
Chip-Level Editor
1. Click on the target Globalxxx vertical line.
2. Select the global input to output connection (if active) and the port.
3. Click OK.
You see a line connecting the digital output port to the global vertical line.
Analog Clock Select
To set Analog Clock Select connections:
1. Click on the target AnalogClock_x_Select Mux.
Figure 2-6. The AnalogClock_0_Select Mux
2. Select a DBAxx or DBBxx PSoC block (as applies).
You see a line from the right side of DBxxx to the input of the AnalogClock_x_Select Mux. The
mux switch shows a connection to this input.
Figure 2-7. The AnalogClock_0_Select Set to Connect to DBB30
Analog Column Clock
To set Analog Column Clock connections: