Datasheet

32 PSoC Designer IDE Guide, Document # 001-42655 Rev *B
Chip-Level Editor
Enable Input for a Digital Block
To set the Enable Input connection on a digital block:
1. Click the Enable text label on the digital block where your target user module is placed. Note that
the name Enable Input is determined by a specified user module parameter.
Figure 2-13. Setting the Enable Input for an 8-bit Counter User Module
2. Select an option from the menu.
You see your chosen input option displayed next to the Enable text label. Your choice option also
appears in the Enable field under User Module Parameters (where you can click the drop-arrow
to change your selection).
Output for a Digital Block
To set Output connections on a digital block:
1. Click the Output text label on the digital block where your target user module was placed. Note
that the name Output is determined by a specified user module parameter.
Figure 2-14. Setting the CompareOut on an 8-bit Pulse Width Modulator User Module
2. Select an option from the menu (None, Global_OUT_x for CY8C25xxx/26xxx, or
Row_x_Output_x for all other PSoC devices).
You see your chosen option displayed (with a connection) next to the Output text label. Your
choice option also appears in the Output field under User Module Parameters (where you can
click the drop-arrow to change your selection).