Datasheet

38 PSoC Designer IDE Guide, Document # 001-42655 Rev *B
Chip-Level Editor
Analog Input
To set Analog Input connections.
1. Click on the target Port_0_x.
2. From the Select menu select AnalogInput.
Figure 2-22. Select AnalogInput for a Port
3. Click OK.
On the device you see the new designation color coded according to the legend along side the
device. The port name and selection also appears in the port-related fields underneath User
Module Parameters (where you can click the drop-arrow to change your selection).
Default Input
To set Default Input connections:
1. Click on the target Port_x_x.
2. From the Select menu select Default.
Figure 2-23. Select Default Input for a Port
3. Click OK.
On the device pinout frame you see the designation color coded according to the legend along
side the device. The port name, the Select column value of StdCPU, and the drive mode of High
Z Analog also appears in the port-related fields underneath User Module Parameters (where you
can click the drop-arrows to change your selections).