Datasheet

40 PSoC Designer IDE Guide, Document # 001-42655 Rev *B
Chip-Level Editor
StdCPU
To set StdCPU connections:
1. Click on the target Port_x_x or select the port from the menu.
2. From the Select menu select StdCPU.
Figure 2-26. Select StdCPU for a Port
3. Click OK.
On the device you see the designation color coded according to the legend next to the device.
The port name and StdCPU also appear in the port-related fields underneath User Module
Parameters (where you can click the drop-arrow to change your selection).
XtalOut
To set the XtalOut connection:
1. Click on Port_1_0 (P1[1]) or select Port_1_0 from the menu.
2. From the Select menu select XtalOut.
Figure 2-27. Select XtalOut for Port 1 0
3. Click OK.
On the device you see the designation color coded according to the legend next to the device.
The port name, XtalOut, and the drive mode of High Z also appear in the port-related fields
underneath User Module Parameters (where you can click the drop-arrow to change your
selection).
XtalIn
To set the XtalIn connection:
1. Click on Port_1_1 (P1[1]) or select Port_1_1 from the menu.