Datasheet

PSoC Designer IDE Guide, Document # 001-42655 Rev *B 41
Chip-Level Editor
2. From the Select menu select XtalIn.
Figure 2-28. Select CXtalOut for Port 1 1
3. Click OK.
On the device you see the designation color coded according to the legend next to the device.
The port name, XtalIn, and the drive mode of High Z also appear in the port-related fields under-
neath User Module Parameters (where you can click the drop-arrow to change your selection).
ExternalGND
To set the ExternalGND connection:
1. Click on Port_2_4 (P2[4]) or select Port_2_4 from the menu.
2. From the Select menu select ExternalAGND.
Figure 2-29. Set External Ground for Port 2 4
3. Click OK.
On the device you see the designation color coded according to the legend next to the device.
The port name and ExternalGND appear in the port-related fields underneath User Module
Parameters (where you can click the drop-arrow to change your selection).
In the device interface you see that all lines from P2[4] are gone.
Ext Ref
To set the Ext Ref connection:
1. Click on Port_2_6 (P2[6]) or select P2[6] from the menu.
2. From the Select menu select ExtRef.
Figure 2-30. Set External Reference for Port 2 6
3. Click OK.