Datasheet

74 PSoC Designer IDE Guide, Document # 001-42655 Rev *B
System-Level Editor
1. Open PSoC Designer
2. Create a new project with an appropriate name.
3. Create the inputs and outputs using these names:
 WDG (Drivers > Input > Timing > External WatchDog)
 WDG1
 PWM (Drivers > Output > PWM > any PWM)
 PWM1
 mVolts (Drivers > Input > Voltage Input > DC > Any DC input)
 InterfaceSlave (Interface > Communication > I2C > Slave with Address Pins)
 GenPin (Input > Digital Input > Generic Pin > Any generic pin)
 LED (Output > Display > LED > 7-Segment > Single Digit > Common Anode)
When you are done the screen looks like this
.
4. Click Save and then choose Generate/Build ‘yourproject’ Project from the Build menu.
5. Select the target device configuration and properties.