Datasheet

PSoC Designer IDE Guide, Document # 001-42655 Rev *B 81
System-Level Editor
2. If your design does not already have an I
2
C interface, choose an I2C slave communication inter-
face, and place it on your design. Leave the I2C_Address at the default value of 4.
3. When you do pin assignment for the project, the I
2
C pins will default to P1[7] and P1[5]. You will
need to move them to P1[0] and P1[1].
4. Build your project and program your board.
5. Switch to the Monitor desktop.
6. Plug the I2C-USB Bridge into your board.
7. Plug the USB cable into the I2C-USB Bridge.
8. Plug the USB Cable into your PC.
The board monitor displays Connected.
9. Choose the correct power setting.
 Board Powered if the board has its own power
 5V Supplied or 3.3V Supplied to power the board from the USB bus.
10.Press the Play button to begin monitoring the board.
The board monitor displays Running.