Datasheet

PSoC Designer IDE Guide, Document # 001-42655 Rev *B 83
System-Level Editor
2. Make sure that the Flash Interface is Enabled in the Device Configuration properties when you
choose the device for your project.
Exposing tuning values adds some extra code to your design, so you may want to make sure that
you set Expose Tuning Values to No before you do your final build, especially if resources are tight
or you are trying to fit your final design into a smaller, less expensive part.
The following example shows the process of tuning a driver. This example shows tuning of a
CapSense button on a CY3203 CSA CapSense board. To set it up, choose a CSA Properties driver
to set global CSA properties, several CSA buttons, a Diplexed Slider, and an I2C interface. See the
PSoC Express CapSense Guide for details on how to set up this project. Build the project and set up
the board monitor as shown in “Monitoring Your Design” on page 79.
1. In the board monitor desktop, right click on a tunable driver.