User manual

CY8CKIT-049-4xxx PSoC® 4 Prototyping Kit Guide, Doc. #: 001-90711 Rev. *G 21
Kit Operation
4. Click on Build > Build All Projects.
Note: The UART_Bootloader project is a dependency for the Bootloadable Blinking LED project.
Hence, both example projects must be built by selecting Build > Build All Projects.
5. In the Workspace Explorer, right-click the Bootloadable Blinking LED project and select Set As
Active Project.
Figure 3-8. Set the Code Example as Active Project
The bootloadable project must be associated with the bootloader project's HEX and ELF files.
This will ensure that the firmware code mapping aligns with the code on the target device.
6. Under the 'Bootloadable Blinking LED' code example, double-click the 'TopDesign.cysch' file to
open the schematic view. Select the tab for the Bootloadable Project schematic page if it is not
already selected.
Figure 3-9. Open Schematic View