User manual

48 CY8CKIT-049-4xxx PSoC® 4 Prototyping Kit Guide, Doc. #: 001-90711 Rev. *G
Code Examples
12.Because the project is not designed for the CY8CKIT-049 kit, you need to change the PWM out-
put pin to the LED pin in CY8CKIT-049 (P1[6]). To do this, open PWMExample.cydwr from the
Workspace Explorer.
Figure 5-16. Opening “.cydwr” File
13.Select the LED_GREEN pin to P1[6] in the CY8CKIT-049 kit.
Figure 5-17. 'cydwr' Pin Settings
14.Select Build > Build PWMExample.
Figure 5-18. Building the Project
15.Connect the CY8CKIT-049-4xxx kit to the PC while pressing the SW1 button; this will put the
device into Bootloader mode. Entry into Bootloader mode is shown by the blinking LED.