User manual

CY8CKIT-049-4xxx PSoC® 4 Prototyping Kit Guide, Doc. #: 001-90711 Rev. *G 59
USB-Serial Configuration
3. Click Configure next to the UART mode select.
The Configure UART Settings window appears, which displays the default settings for your
UART-Serial device.
Figure 6-5. Configuring UART Settings
4. Change the UART settings such as Baud Rate or Type by selecting the new values from the
respective drop-down lists, and click OK.
5. Click the Program Device button from the menu options at the top of the Configuration Utility to
program the device with the new settings.
Figure 6-6. Programming the Device With UART Settings
When the configuration has been programmed to the target device, a popup window will be
shown letting you know that programming was successful.
Note: Configurations will not be set immediately. You will need to reset the COM port for the
settings to be applied.
Figure 6-7. Confirmation for Device Programming