User manual

72 CY8CKIT-049-4xxx PSoC® 4 Prototyping Kit Guide, Doc. #: 001-90711 Rev. *G
A.2 Programming a CY8CKIT-049-4xxx Project Using MiniProg3
To use MiniProg3 for programming, connect wires or a 5-pin 100-mil spaced header to the
programming header on the CY8CKIT-049-4xxx board. The programming header is a 5-pin header
indicated on the silkscreen and is labeled ‘PROG’. The suggested part numbers are
Molex 22-05-3051 (right angled male header) and Molex 22-23-2051 (straight header). The
suggested part numbers for 5 pin headers are 5-pin Molex-KK right-angle male header
(Part number# 22-05-3051) or 5-pin Molex-KK vertical male header (Part number# 22-23-3051).
Please see images below for orientation of the header. The CY8CKIT-049 supports both power cycle
and reset programming modes.
Figure A-3. Connecting CY8CKIT-049-4xxx to MiniProg3 using right angled header