User manual

CY8CKIT-049-4xxx PSoC® 4 Prototyping Kit Guide, Doc. #: 001-90711 Rev. *G 79
Revision History
CY8CKIT-049-4xxx PSoC
®
4 Prototyping Kit Guide Revision History
Document Title: CY8CKIT-049-4xxx PSoC® 4 Prototyping Kit Guide
Document Number: 001-90711
Revision Issue Date
Origin of
Change
Description of Change
** 02/03/2014 RKAD New kit guide
*A 03/20/2014 RKAD Moved section 3.2.1 to appendix section A-2.
*B 06/23/2014 RKAD Updated the title in the file properties.
*C 10/09/2014 SASH
Replaced “USB Serial” with “USB-Serial” in all instances across the document.
Updated Introduction chapter on page 7:
Updated “Additional Learning Resources” on page 8:
Updated description.
Updated “Document Conventions” on page 12:
Replaced “PSoC Designer User Guide” with “PSoC Creator User Guide”
Updated Software Installation chapter on page 13:
Renamed Chapter “Kit Installation” as “Software Installation”.
Removed “Kit Software”.
Added “Before You Begin” on page 13.
Added “CY8CKIT-049-41xx/CY8CKIT-049-42xx Software” on page 13.
Added “Install Software” on page 14.
Updated “Uninstall Software” on page 14:
Updated description.
Added “Uninstall USB-Serial Drivers” on page 15.
Updated “Open the “PSoC 4 Code” Code Example in PSoC Creator” on page 15:
Updated description.
Updated Kit Operation chapter on page 17:
Updated “CY8CKIT-049-4xxx USB COM Port” on page 18:
Updated description.
Updated “Programming a CY8CKIT-049-4xxx Project Using the Bootloader” on page 19:
Updated description.
Updated Figure 3-7.
Updated Figure 3-11.
Updated Appendix chapter on page 65:
Updated “Programming a CY8CKIT-049-4xxx Project Using MiniProg3” on page 72:
Updated description.