User manual

22 CY8CKIT-050 PSoC® 5LP Development Kit Guide, Doc. # 001-65816 Rev. *E
Hardware
Figure 4-4. On-board Programming Interface
When the USB programming is plugged into the PC, it enumerates as DVKProg5 and you can use
the normal programming interface from PSoC Creator to program this board through the on-board
programmer.
A zero-ohm resistor R9 is provided on the board to disconnect power to the on-board programmer.
4.2.2.2 JTAG/SWD Programming
Apart from the on-board programming interface, the board also provides the option of using the
MiniProg3. This interface is much faster than the on-board program interface. The JTAG/SWD
programming is done through the 10-pin connector, J3.
Figure 4-5. JTAG/SWD Programming