User manual

CY8CKIT-050 PSoC® 5LP Development Kit Guide, Doc. # 001-65816 Rev. *E 33
5. Code Examples
To access code examples described in this section, open the PSoC Creator Start Page. For
additional code examples, visit http://www.cypress.com.
Figure 5-1. PSoC Creator Start Page
Follow these steps to open and program code examples:
1. Click on a code example from Examples and Kits on the PSoC Creator Start Page.
2. Create a folder in the desired location and click OK.
3. The project opens in PSoC Creator and is saved to that folder.
4. Build the code example to generate the hex file.
5. To program, connect the board to a computer using the USB cable connected to port J1, as
described in On-board Programming Interface on page 21. The board is detected as DVKProg5
6. Click Debug > Program.
7. The programming window opens up. If the silicon is not yet acquired, select the DVKProg5 and
click on the Connect button.
8. The silicon is acquired and is shown in a tree structure below the DVKProg5.
9. Click OK to exit the window and start programming.