Datasheet

I2C Bootloader

Document Number: 001-13258 Rev. *J Page 10 of 39

Parameters and Resources

Default parameters are for informational purposes only. Defaults in your project may be tailored to the

block size of the part in use, or may have been adjusted to give adequate sizes of code areas. After your

project is compiled and tested, you can adjust block sizes to optimize memory use.

Figure 3. Default Parameters

Figure 3 shows the default user module parameters. Periodically, these parameters may be updated in the

source code of the user module, and may differ from the given example.

All buffer names are written to describe their use by an I

C master. For example, the I2Cs_pRead_Buf

refers to the location in RAM containing data to be read by the I

C master.

Slave_Addr_HEX

This is a Slave and MultiMasterSlave parameter. It selects the 7-bit slave address that is used by the

C master to address the slave or the MultiMasterSlave when it is in slave mode. Valid selections are