Operating instructions

3-13 (E)
DFP-R3000
(2) Checking 2
Insert a 0.4 mm thickness gauge between the film
retainer rollers (A and B) and the film running surface
of the sprocket.
While lightly pressing the film retainer rollers in the
direction arrow, turn the film retainer rollers.
In this condition, check that the film retainer rollers do
not rotate and that the film retainer rollers and sprocket
catch the thickness gauges.
(3) If the checkings 1 and 2 in steps (1) and (2) were not
satisfactory, loosen the two screws (PSW4 x 12) of
the PAD plate by half a turn, insert an eccentric
screwdriver into the adjustment hole of the PAD plate,
and adjust the position of the PAD plate.
After adjusting, tighten the two screws (PSW4 x 12)
loosened temporarily and perform the checkings 1 and
2 in steps (1) and (2) again.
3-1. Mechanical Parts Replacement
(4) If the checkings 1 and 2 are satisfactory, tighten the
two screws (PSW4 x 12).
(5) Perform the checkings 1 and 2 again.
(6) Perform the film running checking.
(See the section “ 3-4. Film Running Checking”.)
Sprocket
PAD plate
Adjustment hole
Sprocket
Sprocket
Film running surface Film running surface
Thickness gauge
(0.4 mm)
Thickness gauge
(0.4 mm)
Thickness gauge
(0.4 mm)
Thickness gauge
(0.4 mm)
Film retainer 
roller
Film retainer 
roller
PSW4 x 12
PSW4 x 12