Operating instructions

3-20 (E)
DFP-R3000
(4) Adjustment
Adjust RV1 of the SE-437 (S side) so that a pulse type
waveform is generated at A portion of the output
waveform.
The pulse type waveform appears when RV1 is rotated
fully in the clockwise direction and then in the coun-
terclockwise direction.
Adjustment
(5) After the adjustment has been completed, input the
command C0 from the PC keyboard, and then press
the Enter key.
2. P side adjustment
(1) Input the command C1 (press the “C” key and “1”
key) from the PC keyboard at the screen of the termi-
nal software started and then press the Enter key.
(2) Input the command m100 from the PC keyboard and
then press the Enter key.
(3) Shut off the light incident upon the CCD lens by using
a paper.
(4) Adjustment
Adjust RV1 of the SE-437 (P side) so that a pulse type
waveform is generated at A portion of the output
waveform.
The pulse type waveform appears when RV1 is rotated
fully in the clockwise direction and then in the coun-
terclockwise direction.
3-3. CCD Bias Adjustment (SE-437 board Adjustment)
Optics block
Lens
Paper
SE-437 board (S side)
RV1