Operating instructions

3-26 (E)

DFP-R3000

Step 4. CCD azimuth rough adjustment

(1) Input the command m10 from the PC keyboard and

then press the Enter key.

(2) Loosen the S side azimuth fixing screw about a half

turn using hex wrench driver (across 2.5 mm).

(3) Rotate and adjust the CCD azimuth adjustment screws

so that the output waveform of the oscilloscope meets

the following specification.

Specification : A portion (second) of the output

waveform should be parallel.

(4) After the adjustment has been completed, tighten the

CCD azimuth fixing screw loosened at the procedure

(2) above.

Step 5. CCD focus fine adjustment

(1) Connect the filter tool between the TP1 on the RD-35

board and oscilloscope CH1 as shown in the figure.

(2) Input the command m0 from the PC and then press the

Enter key.

(3) Rotate and adjust the fifth and sixth CCD adjustment

screws from the mechanical deck chassis so that the ◊

part (eye patterns) of the output waveform (TP1) of the

oscilloscope CH1 becomes maximum.

(4) Tighten the loosened two hexagon cap screws at the

bottom of the optics block in “procedure (3) of Step 2”

and check that the ◊ portions (eye patterns) do not

change.

3-5. Optics Adjustment

Optics block

CCD azimuth 

adjusting screw

(S side)

CCD azimuth 

fixing screw (S side)

SE-437 board

(S side)

TP4

TP3

TP1

TP2

TP J1

RD-35 board

Oscilloscope

Filter tool

CH1