Specifications
Document Number: 002-30672 Rev. ** Page 38 of 46
PRELIMINARY
CYBT-243068-02
CYBT-243069-02
Regulatory Information
FCC
FCC NOTICE:
The
device CYBT-243068-02/CYBT-243069-02 complies
with
Part
15
of the FCC
Rules. The
device
meets the requirements
for
modular transmitter approval as detailed in FCC public Notice DA00-1407.transmitter Operation is subject to the following two
condi-
tions:
(1) This
device
may
not
cause
harmful
interference,
and
(2) This
device
must
accept
any
interference
received,
including
interference that may cause undesired operation.
CAUTION:
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved
by
Cypress Semiconductor may void
the user's authority to operate
the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help
LABELING REQUIREMENTS:
The Original Equipment Manufacturer (OEM) must ensure that FCC
labelling requirements are met. This includes a clearly visible
label on the outside of the OEM enclosure specifying the appropriate Cypress Semiconductor FCC identifier for this product as
well
as the FCC Notice above. The FCC identifier is FCC ID: WAP3068.
In any case the end product must be labeled exterior with “Contains FCC ID: WAP3068”.
ANTENNA WARNING:
This device is tested with a standard SMA connector and with the antenna listed in
Table 7 on page 14. When integrated in the OEMs
product, this fixed antenna requires installation preventing end-users from replacing them with non-approved antennas. Any antenna
not in
Table
7
must be tested to comply with
FCC Section 15.203 for unique antenna connectors and Section 15.247 for emissions.
RF EXPOSURE:
To comply with FCC RF Exposure requirements, the Original Equipment Manufacturer (OEM) must ensure to install the approved
antenna in the previous. The antennas must be installed to provide a separation distance of at least 8 mm from all persons.
The preceding statement must be
included as a CAUTION statement
in manuals, for products operating with the approved antenna
in
Table
7, to alert users on FCC RF Exposure compliance. Any notification to the end user of installation or removal instructions about
the integrated
radio module is not allowed.
The radiated output power of CYBT-243068-02/CYBT-243069-02 with
the integrated PCB trace antenna (FCC ID: WAP3068) is far
below the FCC radio frequency exposure limits. Nevertheless, use CYBT-243068-02/CYBT-243069-02 in such a manner that
minimizes the potential for human contact during normal operation.
End
users may
not
be provided
with
the
module
installation
instructions.
OEM
integrators and
end users must
be
provided with
transmitter operating conditions
for satisfying RF exposure compliance.