Specifications

7.2.2 Back Panel

1 3 54 6

①

Power: This slot is where the user plugs in the 5V DC power supply of this

unit before connecting the adaptor to an AC wall outlet.

②

Link LED: When the LED illuminate it shows that the device has successfully

detected the transmitter and when it blink it means the device is

receiving transmitter's signals.

③

CABLE ASSOC.: This slot is where the user connects a USB cable to the PC

or Laptop USB port for ID association when first using the system and later

on when establishing a connection with the Transmitter.

④

EDID control switch: The default setting for this switch is HDMI, leave the

switch here as long as the connected display is compatible. When

the EDID control is switched from HDMI to VGA the unit will detect the

sources EDID and record it. Turn off in order to use the built in EDID.

⑤

USB Port: These ports allow the receiver to act like a USB hub, allowing you

to connect an External Hard Drive, Keyboard or Mouse.

Note:



Before removing the USB device, the user must follow the USB devices

hardware removal procedure. Failure to do so will cause the system

to crash.

⑥

Mini USB IN: This port, when connecting to USB port of your PC via USB

cable, supports mirror or video extension of your PC content on your

HDMI display. When connected it will override and replace the wireless

USB connection between TX and RX and the unit then works as a wired

USB to HDMI Converter.