Specifications

CY8CKIT-042 PSoC 4 Pioneer Kit Guide, Doc. # 001-86371 Rev. *D 19
Kit Operation
3.2 Programming and Debugging PSoC 4
The kit allows programming and debugging of the PSoC 4 device in two modes:
Using the onboard PSoC 5LP programmer and debugger
Using a CY8CKIT-002 MiniProg3 programmer and debugger
3.2.1 Using the Onboard PSoC 5LP Programmer and Debugger
The default programming interface for the kit is a USB-based, onboard programming interface.
Before trying to program the device, PSoC Creator and PSoC Programmer must be installed. See
Install Software on page 12 for information on installing the kit software.
1. To program the device, plug the USB cable into the programming USB connector J10, as shown
in Figure 3-4. The kit will enumerate as a composite device. See Pioneer Kit USB Connection on
page 18 for details.
Figure 3-4. Connect USB Cable to J10
2. The onboard PSoC 5LP uses serial wire debug (SWD) to program the PSoC 4 device. See
Figure 3-5 for this implementation.
Figure 3-5. SWD Programming PSoC 4 Using PSoC 5LP
PSoC 5LP PSoC 4
SWDCLK
SWDIO
Reset
P2[1]
P2[0]
P2[4]
P3[2]
P3[3]
XRES
Mini
USB
D-
D+
P15[6]
P15[7]
VDD