Specifications

20 CY8CKIT-042 PSoC 4 Pioneer Kit Guide, Doc. # 001-86371 Rev. *D
Kit Operation
3. The Pioneer Kit’s onboard programmer will enumerate on the PC and in the software tools as
KitProg. Load an example project in PSoC Creator (such as the project described in Install
Software on page 12) and initiate the build by clicking Build > Build Project or [Shift]+[F6].
Figure 3-6. Build Project in PSoC Creator
4. After the project is built without errors and warnings, select Debug > Program or [Ctrl]+[F5] to
program the device.
Figure 3-7. Program Device from PSoC Creator
The onboard programmer supports only the RESET programming mode. When using the onboard
programmer, the board can either be powered by the USB (VBUS) or by an external source such as
an Arduino shield. If the board is already powered from another source, plugging in the USB
programmer does not damage the board.