Specifications

CY8CKIT-042 PSoC 4 Pioneer Kit Guide, Doc. # 001-86371 Rev. *D 21
Kit Operation
3.2.2 Using CY8CKIT-002 MiniProg3 Programmer and Debugger
The PSoC 4 on the Pioneer Kit can also be programmed using a MiniProg3 (CY8CKIT-002). To use
MiniProg3 for programming, use the J6 connector on the board, as shown in Figure 3-8. With
MiniProg3, programming is similar to the onboard programmer; however, the setup enumerates as a
MiniProg3. Only the RESET programming mode is available.
The board can also be powered from the MiniProg3. To do this, select Tool > Options. In the
Options window, expand Program and Debug > Port Configuration; click MiniProg3 and select
the settings shown in Figure 3-9. Click Debug > Program to program and power the board.
Note The CY8CKIT-002 MiniProg3 is not part of the PSoC 4 Pioneer Kit contents. It can be
purchased from the Cypress Online Store.
Figure 3-8. PSoC 4 Programming/Debug Using MiniProg3